I'm going to remove the 4.10 posi set-up from a 71 12 bolt axle. I was told the parts are all used original Eaton but never driven after it was assembled. I'll get pics up when I get it out (soon). Just wondering if there is any interest within the club for this before I throw it on craigslist.
Tim H said
Mar 17, 2013
Ya I would be interested in looking at it.
Lost in the 60s said
Mar 17, 2013
OK, I'll pull it out tomorrow and get pics. This is for the Eaton 4 series posi carrier and the ring & pinion with all bearings and races. I'm keeping the rest to install a 3 series and gears.
Tim H said
Mar 17, 2013
Mitch
That is a little steeper than I can use.
But thanks anyhow.
-- Edited by Tim H on Sunday 17th of March 2013 06:34:23 PM
Lost in the 60s said
Mar 17, 2013
No numbers on the ring but the pinion has 9-41= 4.56 ratio...
I'm going to remove the 4.10 posi set-up from a 71 12 bolt axle. I was told the parts are all used original Eaton but never driven after it was assembled. I'll get pics up when I get it out (soon). Just wondering if there is any interest within the club for this before I throw it on craigslist.
OK, I'll pull it out tomorrow and get pics. This is for the Eaton 4 series posi carrier and the ring & pinion with all bearings and races. I'm keeping the rest to install a 3 series and gears.
Mitch
That is a little steeper than I can use.
But thanks anyhow.
-- Edited by Tim H on Sunday 17th of March 2013 06:34:23 PM
No numbers on the ring but the pinion has 9-41= 4.56 ratio...
You still interested, Tim ??
Not sure if I want to separate them at this time.
Kinda figured that.